AutoCut
Check Our Our Other Brands!
The powerful, automatic
firewood-producing machine.
AutoCut Drive Type
Article No.
Type
Propulsion
Weight lbs.
M1160
M1150
E20.5
Z
Stationary model, 15kW-S6 and 5.5kW-S6 E-motors, CEE 32A,Timber
chute after the saw with ejection height approx. 1m,24V on board
2866
2645.5
Stationary model, tractor drive with PTO speed 480rpm, power
consumption 25kW, PTO drive on the side, timber chute after the saw with
ejection height approx. 1 m, universal joint shaft and 3-pin permanent
power plug 12V-20A required! (DC-DC converter 12-->24Von board)
Conveyor Belts
Article No.
Description
Ejection Height
Max. ft
F4
F5
Conveyor belt 1.5m hydraulically foldable, ejection height 5.25 - 8.2 ft
8.2
9.8
Conveyor belt 8.2 ft double-action hydraulically telescoping and foldable, ejection height 1.6-3.0 m
Special Equipment
Article No.
Description
Z
T
PTO unit 30kVA for additional PTO drive lengthwise on M1160, additional voltage supply CEE16A
Tractor longitudinal chassis. Chassis not approved for road traffic, hydraulic support foot
Accessory Equipment
Article No.
Description
M7380
Chip extraction unit E3,0-4003.0 kW E-drive 400 V, S6, CEE 16A, with 6.5 ft suction hose (∅ 6 in) and 26.25 ft
pressure hose(∅ 4 in), with hand-geared trolley
9 in
Cutting– Ø max.
2755 lbs
weight min.
5.88-8.83
cubic foot/m
The fully automatic firewood processor
ideally achieves, depending on cutting length
and billet size, a throughput of 15 cubic
meters per hour with one operator.
With the touchscreen of the electronic
control unit, you can easily set the desired
cutting length and the admissible length
deviations of the billets ready for the stove.
Cord firewood with a max. length of
47.24 in can be put continuously in the timber
trough at an ergonomic height. The
continuous feed passes the timber past the
optical measurement sensor to the saw blade.
The precise measurement of the billet length
and the cutting to the desired length into
billets ready for the stove is realized by the
electronic control unit.
Every billet is sawn (depending on billet
length, cutting length and tolerances) in such
a way that no offcuts are produced, or cut
into billets of the same lengths with offcut.
The billets ready for the stove are loaded via a
timber chute or by means of a conveyor belt.
Northeast
Implement
Products
Copyright © 2016 Northeast Implement
Northeast Implement
&